Don't do it! Sounds like you might need a seat post at a different angle or a fitting. Good luck.
To disable ads, please log-in.
I want to move my saddle a bit backwards, but I noticed that the clamps holding it are already at the end of that area with ruler-like markings. There is plenty of space on either side of these ruler-like markings for potentially sliding the saddle backwards. Can I do this safely or is moving the clamp out of this range a big no-no?
Don't do it! Sounds like you might need a seat post at a different angle or a fitting. Good luck.
Yes, I do have a Trek OCLV 9800 "Apocalypse" Bike thanks for asking!
I would perhaps buy a seat post with a "set back". It will help with moving your seat back. I am not sure if moving the seat beyond the markings is dangerous or not.
"Opportunity is missed by most people because it is dressed in overalls & looks like work" - Thomas Edison
Here's what I've wondered though, the zero mark on the rails, is that the limit for the forward end of the clamp, the center of the clamp, or something else?
Speed comes from what you put behind you. - Judi Ketteler
I think it depends on the saddle manufacturer. I have a Serfas Dual Density saddle with markings that clearly can't be limits - it would only allow you to move the saddle back/forth a small amount. In this case, I think the numbers are just for convenience in making adjustments. But on my Selle Italia Diva, the markings are definitely limits for saddle positioning (according to the included instructions).
Oh thanks so much for the replies! Since I started this thread I've been to the LBS for a bike fitting. They already ordered a seat post with setback and we're just waiting for its arrival. In the meantime, my saddle has been raised 2-3 cms more and pushed as far back as the rails allow. My cleats were also adjusted. It's been working so far... knee weirdness is gone.
Nice to hear. Happy cycling. Keep us posted about seat post etc.
"Opportunity is missed by most people because it is dressed in overalls & looks like work" - Thomas Edison