braking in the drops

[Becky]

My gut reaction from the photo is that the bar angle is ok, but the the levers are too high on the bars..... Take that with a grain of salt...photos aren't as good as in-person eyeballing....

What's the bar width? For me, too-wide bars can skew my reach, even if the rest of the bike fits well.

I think that I would start by untaping the bars partway, moving the levers down a touch, and then retaping. I like to have a nice flat transition from the bar top to the lever's hood and that puts my wrists in a relaxed neutral position. See if that makes things any better...

Start with the free stuff first, right?

[jessmarimba]

Supposed to be 42cm bars? I have pretty narrow shoulders but they don't feel too wide...I don't think...not sure how they should feel.

I tell ya what, my back loves the different positions these bars allow. Heaven. Now to make my wrists as happy...haha.

[margrette]

shifter levers/brake levers same idea...

[malkin]

Is it comfy to brake while your hands are perched on the hoods?

Is it too big of a reach no matter what? ( If no, you might need smaller reach brakes.

Is there a place in the drop where it is a comfortable reach to to brake lever (even if it isn't a realistic position for riding)? (If yes, you might want to move the levers so you can reach them from a realistic riding position.)

[malkin]

I just reread your OP...to reduce strain on your wrists, you might try dropping your elbows and thus your entire upper body. This will require greater ab/core strength.

It's always something.

[jessmarimba]

It isn't strain so much as an impossible angle, which would be cured by lowering the brakes as margrette and Becky suggested. My back actually feels better on the flat part of the bars or bent over lower in the drops...halfway up with my hands forward to kinda try to reach the brakes, the muscles pull over the screws in my back.

The brakes are unreachable on the hoods as well, I generally use them by wrapping my entire hand around the little plastic brake support thingies (what are those called?)

[OakLeaf]

If you can't reach the brakes on the hoods either, even when they're that high, you probably just need shorter reach levers. Expensive ... but you need to be able to brake.

[DebW]

Looks to me like the bars are tilted up too much. Try making the bottom of the drops flat and see how that feels.