Should I try to change my bar tape & shifters myself? (scared newbie)

[Hartmame]

I'm hoping taping the bars isn't too tough, I have my new frame built up and ready except for the bar tape so while I'm dragging my feet I really feel its doable. You tube has several videos.

As for the barend shifters, what size is the cassette ? 6 speed? My brother wants to do the same and I saw some compatible friction shifters at orangevelo that would work. Though I agree that it would be easier and less time consuming to have a shop do it. When I did mine I scheduled for someone at the shop to take a look at the job I did to make sure I got it right.

[OakLeaf]

Heh, maybe it's just me, but I find shifter installation and adjustment WAY easier than wrapping bars. With bar tape there's finesse every single turn of the tape - shifters are just a matter of install, position, adjust. I've never done bar-ends, but I can't see how they'd be much different from other types.

It seems to me that wrapping handlebars is mainly a matter of practice and patience. Your LBS mechanic who does it a dozen times a day can do it in three minutes and have it look perfect. Me, who might do it once every other year, it always takes at least five re-wraps and even then it's lumpy at the bar end.

But heck ... your question was should you try. If you're asking the question, that means you want to, and so the answer to should you try is absolutely! It's a really good skill to have, and even if it doesn't look perfect, you'll have the sense of accomplishment, and you'll have that much practice under your belt for the next time you do it.

[Becky]

Oak is right- taping is all about patience and practice. Go slow, be prepared to unwrap and re-wrap sections, and check out the instructions at http://www.parktool.com/blog/repair-...ation-drop-bar.

But you should definitely try it yourself!

[lph]

Taping bars isn't hard, even if you're not real craftsy. I'm not either, but I did it on my first try without any trouble. Just pay attention to how you unwind it - snapping photos as you go can be a good idea, especially when you come to the bit around the shifters - and keep in mind that you want to reverse that.

I would go for doing the shifters yourself, as long as you know that you have shifters that are compatible*. Changing a shifter cable is easy, and adjusting the derailleurs afterwards isn't hard if all the parts involved are in good condition. The worst that can happen is that you route something wrong, it doesn't work, and you take it to your lbs for them to fix. It's really hard to break or ruin something unless you're working with corroded parts or go out to ride with something obviously set up completely wrong.

And it's soooo much fun to do it yourself! Take your time, ask questions if you get stuck, check out youtube, sheldon brown and Park Tool, and even if you have to give up you'll have learnt a lot about your bike.

*I don't know stem shifters, but I've switched and adjusted other shifters and it was def. among the easier things I've done.

eta: http://sheldonbrown.com/gloss_st-z.html#stemshifter
ok, now I know what stem shifters are, thanks to Sheldon Browns almost-but-not-quite-condescending article... |-)

[chincitop]

You girls always make me feel better when I'm all shaky! Thank you all for your encouragement, I think I'm definitely going to try this! I rode her today, only about 12 miles, and despite her age, the shifters are in great condition, but they are SUCH a pain in the ***. Particularly when I'm shifting up and I'm pulled down really low to the frame/bars. I either have to one hand reach under myself or sit up in order to shift, and it's obnoxious. I almost tipped today trying to do it

[Hartmame]

I taped my bars. I'm sure it is rough looking but it will work for this summer.