Rides Dec. 10th

[Tri Girl]

A group of 6 of us did our monthly Cupcake Ride. Rode 11 miles total. Had to go to the Whole Foods since the cupcake shop we were going to wasn't open for business yet. A nice, leisurely ride.

The attire is supposed to be dresses and such, but everyone wore spandex (but me). It's still a fairly new ride, so hopefully as the weather warms up, more people will dress fancy. It's not a hammer-ride, but a ride to show people you can ride in normal clothes. Oh well.

[hebe]

I'd come on your cupcake ride if I lived closer, tri girl!

I did an errand run yesterday on my Marin, only about 4 miles or so on a very chilly and bright morning. I get such a high out of not queuing to get into town, not queuing for parking spaces, not paying for parking...

[Crankin]

Rode just under 20 today; it was about 35 for the whole ride and very sunny. I used my new winter road shoes for the first time, with my heaviest socks (hiking socks) as I wanted to see what it would feel like without the chemical warmers. My toes were cool, not cold, I had plenty of room to move my feet around, and it was OK for this temperature. Closer to 30 or below I might add the chemical warmers again, as I hate wearing thick socks. The shoes are much more comfortable than wearing my regular shoes, booties, chemical warmers. I also wore my knickers under my tights, which was fine. I actually was a bit hot, after 6-7 miles, which leads me to believe my LS Craft base layers are only for temperatures less than 25 or 20. I had to undo the pit zips on my jacket.

[Catrin]

Wooot I was able to ride OUTSIDE today
12.5 miles in one hour - I pushed it the first 30 minutes and just went exploring the rest of the time on some neighborhood streets.

No neck pain during the ride, though some of that has come back over the last two days. I had planned on hiking today but there was so much sunshine and no wind...and the temps had edged up to 35 degrees. AND I've not worn my PI Amfibs before, time to ride

I decided when I started that I would only ride for an hour as I've not been able to do any riding in temps <48 this season. I wore my smartwool base layer and smartwool long-sleeve full-zip and thermal jacket. I just had on a pair of regular PI bike shorts underneath my Amfibs, for my feet had toe covers and chemical warmers. On my head I had ear warmers, a smartwool balaclava. I think I've figured out how to keep my body warm down to about 30 degrees with low winds. My feet will need a little more but I think that is working out as well. I just need full shoe covers when I can swing it

[luv2climb]

I found another nice peaceful road with extremely light traffic, which is a good thing considering how narrow the road is. It's probably one of those private roads I've seen in the area. They seem to have the best climbs, and this one was no exception. Lots of grades in the mid to upper teens and even some in the twenties. Max grade was 23%.

I mounted my GoPro on the head tube of my Sirrus for a much more stable video than the ones I've posted where the camera was mounted on the handlebars. You can see my front tire slinging around in the video, so imagine how shaky it would be if the camera was on the bars.

I had to ride the Sirrus because I am still car-free until January, so I have to take light rail to the end of the line in Folsom if I want to do any climbing. Even though my road bike is a low-end Specialized Dolce Triple, it still looks too nice to take on the train with all the shady characters I see on there.

I've been doing this every weekend since my truck got totalled at the beginning of November.

http://connect.garmin.com/activity/134070153#

Here's the ride video with GPS data overlay from my Garmin: http://www.youtube.com/watch?v=RhzHYfXD6fc

Top of climb. Notice how hazy it is.

[Blueberry]

Just curious:

How do you tell the grades of the roads? My Garmin has been notoriously inaccurate - just curious if there's a better way?

[luv2climb]

I've had some wildly inaccurate speed and percent grade readings too, usually while riding through forested areas.

On yesterday's ride I noticed the Garmin behaved itself a bit better. It could be because the camera was on the head tube, not right next to the Garmin on the handlebars where it could be a potential source of electrical interference. I'm not positive that a camera can cause that type of interference, but I have seen the percent grade readings go absolutely nuts at the beginning of a ride when there was a camera mounted right next to the Garmin. Also, electronics can cause interference to other electronics. That's the reason for the FCC warnings in the owner's manuals of just about every electronic device out there.

The only other way I've heard of for a cyclist to measure grade seems a bit cumbersome-use a plumb bob or some other crude homemade device.

I have seen pictures of a simple non-electronic inclinometer that mounts on a bike, but I have no idea who makes it or where you can buy it.

[luv2climb]

I just remembered something else that may contribute to inaccurate readings. I don't have the speed/cadence sensor because I have too many bikes for it to be cost effective to outfit every one of them. Besides, I'm not sure how well a wired sensor would work on bikes that fold up like my Dahon and Bike Friday.

Without the speed/cadence sensor, the Garmin is totally dependent on satellite signals for ride data (with the possible exception of the barometric altimeter). If there is any kind of interference like what you get when riding through heavily forested areas, you will get inaccurate readings.

[Blueberry]

Mine quite frequently tells me I'm climbing a 17% grade when I'm descending and the reverse. Doesn't seem to be any rhyme or reason to it that I can tell (i.e., doesn't only happen in one spot). I don't usually ride with other electronics except a cell in my saddle bag. Who knows....

ETA: For distance, I believe it to be accurate. It's just grade that's so bad for me.

[Susan Otcenas]

Saturday was really freakin' cold, but I'd made a commitment to ride with friends, so I got through it. 70 miles, high of 35 degrees, never saw the sun. Brrrrrr. We stopped for hot drinks more than once.

[luv2climb]

Mine quite frequently tells me I'm climbing a 17% grade when I'm descending and the reverse. Doesn't seem to be any rhyme or reason to it that I can tell (i.e., doesn't only happen in one spot). I don't usually ride with other electronics except a cell in my saddle bag. Who knows....

ETA: For distance, I believe it to be accurate. It's just grade that's so bad for me.

That is bizarre! I can't say I've experienced that with mine, just greatly exaggerated grade readings while climbing (26% on a 17%, for example). Also, fluctuating speed readings.

[azfiddle]

I never noticed those weird readings around Tucson, where we are not in forests, but when we took a trip the Pacific Northwest, I saw very crazy numbers on the Garmin.

[Gypsy]

I rode too!

27 miles on Saturday and then 33 miles on Sunday. Got wet on Sunday, a friend got a flat, and we were late taking off because I couldn't get her bike on my bike rack.

But we ended the Sunday ride with brunch.

[chosen1]

I rode on Sunday as well. Ended up doing 33mi or so with 2 guys from the local bike club. I totally surprised myself and was able to keep up w/them avg 19.5mph for the ride. I hadn't been able to ride much the last few weeks plus it's been "cold" here and I'd much rather just get my crossfit on inside the gym than freeze on the bike. We rode on what was unchartered scenery for me which made the ride that much more enjoyable. They were both really nice about making sure I was comfortable that that pace etc etc. I plan to ride today as well, I actually miss riding just harder to do now that it gets dark so early!

[redrhodie]

It's not the 10th anymore, but I got out for 18 miles this morning. It was in the 20s, but I've acclimated. It was a pretty day, without much action. Just what I needed.