I hope so!!![]()
I hope so!!![]()
I live in houston which is flat flat flat- I ride almost exclusively in my big ring with the back derailleur somewhere in the middle. Because I have a bad knee, I tend to need a little bit or resistance to keep the knee stabilized. I tend to run through chains a bit more than some people because I am always in the big ring but I'd rather make progess than sit and spin chicken legs.
just saying- do what feels good to your knees and to your endurance.
marni
marni
Katy, Texas
Trek Madone 6.5- "Red"
Trek Pilot 5.2- " Bebe"
"easily outrun by a chihuahua."
I am new to this gig too and have been messing with my gears, trying new things since I started riding a few weeks ago. I live in Florida... also flat, flat, flat, so I've found I also spend about 95% of my time on the big ring in front (I still haven't learned the terminology either and it's way too early in the morning for new vocab right now).
My quicky advice on gearing would be to remember this: the bigger the rings, the further you will travel on each rotation of the crank (pedals), and the harder it will be to pedal... don't be afraid to move to that third ring in front and move down al ittle in back, then see how fast you go pedaling your heart out--I think you'll be amazed how easily you'll be able to stay with the pack! Good luck!
Thanks for all the encouragement everyone, I will definitely give the big ring a try this week! It is fairly hilly around here, so I'll have to get used to shifting both the front and the rear to accommodate for the terrain. Although, I think on the 19 mile route, there are longer flat sections than I am used to.
Just don't wait to shift... If going uphill you want to be able to ease off a little when changing gear... Doing so while under load (hammering up that hill) may leve you in a gear that you can't sustain. I had to learn that one the hard way![]()
Starbucks.. did someone say Starbucks?!?!
http://www.cincylights.com
Shannon, I think that is my concern...if I'm flying DOWN a hill in the big chain ring, but then getting ready to go UP another one....do I shift down in the front first, then start adjusting the back? Or vice versa?
I'm so confused!! lol
@jlnc, it will depend on how much of a decrease you want. If you want pedaling up that hill to be A LOT easier quickly, shift down in the front (remember, those make the biggest differences), then adjust the back (more subtle changes). Hope that helps.
"Opportunity is missed by most people because it is dressed in overalls & looks like work" - Thomas Edison
Change the rear first by about 2 or 3 gears followed immediately by a shift in the front. And as mentioned earlier, ease off the pressure on the pedals slightly when shifting. It does take a little practice so be patient.
"Only those who dare to fail greatly can ever achieve greatly" (Robert F. Kennedy)