Quote Originally Posted by Becky View Post
Yes, it does to me. It's a non-adjustable riser stem. There are adjustable ones out there, but I'm not a fan. You have to get the "hinge" bolt wicked tight, or run the risk that it shifts on you at the worst time. And I'm not sure that an adjustable would go much higher than the stem that you have now.

What exactly are you looking to change with regards to fit?
My bars seem a little too low and this is causing problems with neck/back and the ability to move my hands to get to the bar-end shifters. My arms are flexed and hands relaxed, so it isn't from a death grip (I have arthritis in my hands so I know when I am holding on too tightly - it is PAINFUL). Of course some of this is from being a new rider, but not all of it.

A proper fitting will be done, but I have to wait until I get more miles on the bike. For now I will try lowering my seat-post a bit - which is a short-term solution but hopefully will help. Am also considering calling the LBS and begging them to forgo the 150 mile requirement for a full professional fitting...