Bent CF Fork dropouts

[TsPoet]

I'd call it toast.

You can't re-bend aluminum (it's set and heat treated) even if it wasn't attached to (and possibly damaged) carbon-fiber.

I just lost an entire aluminum frame because the rear-end got bent out by 5-7mm (yes millimeters). If you can see the bend in the fork dropout I'd not trust it again. When those things fail it's UGLY!

I can see it, and a the wheel/new skewer won't slide into it, it will have to be straightened before a wheel could even be put on it.
I think a new one is prudent, I was just hoping.
I'm also on the heavy side, so maybe don't want to push it.