Topeak road morph - mounting?

[withm]

I have the Blackburn pumps on my other bikes. They have the offset bracket so they are mounted on the seat tube under the water bottle cages. If I can get that bracket separately, I'm inclined to buy the Road Morph for my new bike. I do carry CO2 as well, but prefer the pump for partially inflating the new tube before installing it in the tire. And on those bad days when you run through the CO2 cartridges and still get flats...

As far as cutting the tie wraps - using those little nail clippers is the best for trimming the loose ends cause it will cut very close to the opening and the result is NO sharp edges on the tail end of the plastic.

I could also use velcro to hold the pump to the top tube, but then it interferes with the water bottles so that really doesn't work for me.

I just looked and Performance has the bracket for under $2. so as long as the Road Morph is the same diameter as the Blackburn it ought to work just fine. We shall see. It never occurred to me that the bracket was available separately so I'm really glad I posted here. Thanks!

[Thorn]

I just looked and Performance has the bracket for under $2. so as long as the Road Morph is the same diameter as the Blackburn it ought to work just fine. We shall see. It never occurred to me that the bracket was available separately so I'm really glad I posted here. Thanks!

The Blackburn is a tad bit larger in diameter. I line the clip with a segement of old inner tube and the Road Morph fits nicely.

[owlice]

I bungeed my Morph to the down tube.

[msincredible]

I used my old Planet Bike pump holder that fits under the water bottle cage (the pump sucked but the holder was decent) and put it there with a velcro strap. This is a 48cm bike.