Some thoughts on Gilles Berthoud Fenders

[boy in a kilt]

Here you go.





Sorry if the bottom one is a little blurry. That is a harder picture to take than common sense would dictate. Or I'm not very good with a camera.

Nothing really fancy about the hardware. Couple of machine screws with washers and bolts.

Like I said in the above post, a small guide hole will do wonders. The drill bit will tend to slip easily if you don't. Put the edge of the fender over the edge of a table and use a nail or something to make a deep dent where you want the center of the hole to be. The tip of your drill bit will sit right in it and be less likely to mess up the finish.

[RoseC]

Thanks! That's very helpful!