Quote Originally Posted by SadieKate View Post
Lisa, you're going to look for any out, aren't you?

....So, what's your next reason for why 2,800 miles between truings is an acceptable level?
Well the only thing you quoted that I don't quite get is why the Mavic wheels needed to be re-trued right after you bought them.

Again, what I think happened with my wheel, the whole story this time: A spoke broke on my rear wheel. I took it to my LBS where they replaced that spoke. Actually, they replaced THREE spokes-- because upon close examination we discovered the REASON that spoke broke and two others were nicked/bent right near the hub. It had happened when I had adjusted my derailleur setting (not very well...I'm learning) and the chain came off while I was cranking up a hill. Apparently the chain jammed in there and nicked/bent several spokes near the hub before I stopped and put the chain back on. I didn't realize at the time that the spokes had been nicked. (I know better now and I check my spokes often) Anyhow, they replaced 3 spokes and I took the bike home.
It was shortly after that when I noticed my brake pad lightly skimming the rim back there and I could see the wheel was not straight when spun. It had been fine before the spoke incident. So I took it back and he said he needed to retension all the spokes, which he did and it's been fine since then. My feeling is that he did not properly retension the spokes all around when he replaced the 3 spokes, I suspect he rushed through the job or had one of his teenage mechanics do it. I feel that's why the wheel was not straight, not because the wheel itself was badly built.
It's an LBS that I would not go to for major bike work, because they have highschool boys working back there sometimes fixing bikes, but the owner himself had done a nice tuneup previously for me, and I trusted him to do the spoke thing. It is the nearest and most convenient place. Not sure if I'll use them anymore except for really easy stuff.
But look, if you've decided my wheels are poorly built, I'm not going to keep arguing about it. It's easy to judge other people's bikes. And I fully realize that you know way more about bikes than I do. I sincerely AM happy for you that you've had such good experiences with your bikes in the past. All I can do is keep muddling along the best I know how, learning more along the way. But I still don't believe my wheels are poorly built.