Newbie question and patching

[MollyJ]

I have a road bike, Trek Madone. When I get a flat, they just sell me a new inner tube and I have some inner tubes as part of my flat kit.

DH is "old school" and wanted to teach me about patching.

Is patching skinny, road bike tires practical? Or does our disposable society just discard because we can?

[OakLeaf]

Carry a patch kit and know how to use it. The number of flats you will have on any given ride is the number of spare tubes you have, plus one.

Stick-on patches are quickest, simplest and most compact for the road. I'm told they're not as reliable as the old-school patches though - I've never had a glued patch fail [touch wood].

If you have enough spare tubes to get you home, then use the glue type to patch them. It's a whole lot easier to find small holes and patch them when you have access to a pail of water and clean towels! Let the glue cure overnight before you fold them back up for your seat pack. When you pack it up, use extra powder, since any excess glue will be even stickier than the tube itself.

[TsPoet]

Carry a patch kit and know how to use it. The number of flats you will have on any given ride is the number of spare tubes you have, plus one.

I agree!
I disagree with the stick-on patches being quicker, they really aren't, they are just sold that way. I highly recommend simple - IMHO the best patch kit is this one
http://www.rivbike.com/products/show...tch-kit/10-048
I now just buy the smallest patches I can find and glue - don't even need a kit. Read the instructions and let the glue dry until tacky, put the patch on, and you are good to go. the only patches I've had fail were the ones that I put on next to the puncture instead of on it - I hate to admit it, but I've done that more than once. If you aren't sure exactly where the tiny hole is, put water (or spit) on the area, a little air in the tire, and watch it fizzle. soapy water works the best, if you are home.

[MomOnBike]

Agreed. Learn to patch a tube. It's not hard, and you look so competent.

I find patching tubes relaxing and enjoyable - I tend to grab DH's flat tubes from him and start patching before he even knows quite what is happening.

That said, sometimes old tubes can sure make good shims and rubber bands. All you need then are some scissors.

[Velocivixen]

@Mollyj, you asked if patching skinny, road bike tires is practical. You don't patch the tires, you patch the tubes. I presume that's what you meant. I think that when you're out on the road and just need to get home, replace the entire tube. Once home, you can find the leak, assess, then patch the tube if you want.

[MollyJ]

velocivixen, I did mean tubes...my brain sometimes thinks tire when it means tube but I know the difference. I'm kind of impressed with the response here. DH will be gratified.

[Crankin]

Maybe I am playing devil's advocate, but I don't know anyone who patches tubes. None of my friends are racers (except SheFly), so that's not the reason. I, for one, would not want to use a tube that had a hole in it...
I've had 4 flats in 10 years. I carry 2 tubes and I could carry more if I needed to. The one time I had an issue, it was the tire that actually was cut; but we had planned wisely and had about 6 tubes, so even though it took 2 of them to figure out it was the tire, I was prepared.
I keep a supply of tubes at home, so I am not always running to the computer to order more. But, I've had very little need to do this.

[nscrbug]

I'm with Crankin on this one. I would not feel comfortable using a tube with a patched up hole in it. Maybe it is wasteful and considered not being "green", but I've never not made it back home on a replacement tube. I'll stick with replacing over repairing my tubes. JMO. And FWIW, I also do not know anyone personally, that patches their tubes after a flat.

[OakLeaf]

I think one of the tubes I've been running for the past couple of thousand miles has three patches.

I have tens of thousands of miles in my lifetime.

I've had professionally installed plugs in car tires fail, twice. I have never had a patched bici tube fail.


Whatever your usual routine, it's one of those things you need to have and know how to use, because there will come a time when you need it. Same thing with a pump. Even if you prefer CO2, you can only carry so many tubes and so many cartridges. After you run out of those, 20 miles from anywhere, an hour and a half drive from anyone who knows you, and outside of cell range, do you want to fix your tube the old fashioned way, or do you want to walk?

[TsPoet]

I'm with Crankin on this one. I would not feel comfortable using a tube with a patched up hole in it. Maybe it is wasteful and considered not being "green", but I've never not made it back home on a replacement tube. I'll stick with replacing over repairing my tubes. JMO. And FWIW, I also do not know anyone personally, that patches their tubes after a flat.

LOL. I live in tackweed-central. No one here rides without patched tubes. I have set myself a 5-patch-per tube limit rather arbitrarily. I have never had a patch (that was done right) be the cause of another flat - it's always another tackweed that does it.
I couldn't afford the ~20+tubes/year. Especially since I have 5 different wheel sizes on my 4 different bikes. (My velo has a 26" and 2-20" wheels, my commuter has a 26" and a 24" tire, my 'racing' bike has 2-650s, my trike has 16" tires all around)