Printable View
How do you clean your Camelbak?
How often?
I only use water in mine, but I know my mouth has germs. But sometimes I just rinse with water.
Am I going to die?
I mean, you know, from camelbak gunk disease?
If I put soap in, I feel like I have to rinse and rinse and rinse and rinse for fear of getting a mouth of soapy water next time I drink.
Oy, I've been hanging around here waaay too long. :cool: :D
Here are some old threads on that topic. The general consensus is, denture cleaner tablets. (I kids u not.)
http://forums.teamestrogen.com/showthread.php?t=1378
http://forums.teamestrogen.com/showthread.php?t=948 --> scroll down to post #23 onward.
Hee hee, this was the thread where I said I wouldn't use a CamelBak. Well, three years later I finally got one and I really like it. :o
hth, - Jo.
I ride with 1/2 strength cranberry juice + electrolytes. I drain out everything I can, rinse out the reservoir and then drain it through the tube until it runs clear. Then, I add one drop of dishwasher liquid, shake it up, and drain it through the tube. Then I rinse the reservoir clear of soap and then drain, again, through the tube. Then, I do a preliminary drying inside with a paper towel, then stuff it with a clean, dry paper towel and hang it to dry. Every so often I'll clean out the tube with a special tube brush. It sounds like a lot of work, but it really only takes a few minutes. Of course, I'm sometimes so tired from my ride that I need to leave it til later in the day.
I use a few drops of bleach, soak a little, rinse really well. I use gatorade so it'd get pretty icky in there otherwise. I've got a brush for both the 'back and the tube.
All I know is I once poisoned myself by not cleaning out my flashflow bladder well enough. It was my running one- so a waistpack, and the bladder didn't come all the way out, so I guess I was bad about getting the gunk out. I went for a week getting ill after every run before I figured out that I was poisoning myself! :eek:
Now I'm diligent about it. I soak the entire thing in a bleach/water solution once a week and clean in out with soap and water in between .
Kind of a pain, but getting the revenge is worse!
You can dry the inside of the reservoir with a paper towel?
I need to investigate my camelbak more closely, because I had no idea you could "get in" it!
I guess even though it has had nothing but water in it, I need to go to more trouble.
You're not alone, pooks -- I normally just rinse my bladder with hot water, squirt out the tube, wash the mouthpiece with a little dishwashing liquid and hang it dry. I only use water in mine too. So far no problems in a year of use, but I guess I should be a bit more careful!Quote:
Originally Posted by pooks
Emily
I have a lot more experience than I wish I had with the dreaded funk. :eek:
I always rinse with plain water, only on rare occasions will I add a few drops of bleach to the rinse water or hot water with denture cleaner tablets. A few times I've used a long bristle brush (available in a hydration bladder cleaning kit) to scrub the tube out if it's looking suspiciously cloudy.
As for drying, first I drain the tube and try to shake out most of the water. Then I use a paper towel to sponge off as much of the inside that I can reach. Some of my hydration bladders have a big opening that I can stick my whole arm down - those I dry completely with paper towels. Others have a small filler cap - what I do in that case is stick some paper towels just inside the filler neck and use it to sop up little trickles of water as much as I can.
As long as I rinse and dry the bladders within 12 hours of using them, I rarely have a problem. Forgetting to do this, or storing a damp bladder, or leaving a bladder half-full forgotten in a backpack for a week (oh, I've done it!) usually results in the Black Plague. Note: I only use water in my hydration packs.
Clean it???
You're supposed to clean it??? :confused: